HomeHome  CalendarCalendar  FAQFAQ  SearchSearch  RegisterRegister  MemberlistMemberlist  UsergroupsUsergroups  Log in  
Share | 
 

 A technical question

Go down 
AuthorMessage
Crafty



Location : North Alabama
Registration date : 2013-09-06

PostSubject: A technical question   Thu Dec 28, 2017 6:34 pm

Ok, time to ask for some help. Iíve been wanting to do a full bend pipe but drilling the draft hole has me stumped 🤔. Ideas? Help? Iíve done multiple 1/4 & 1/2 bent and those are to bad however.....thinking about a full bent just makes me want a bourbon 🥃 to sip while trying to figure it out!
Back to top Go down
View user profile
Richard Burley

avatar

Location : North Coast NY
Registration date : 2011-04-09

PostSubject: Re: A technical question   Thu Dec 28, 2017 8:09 pm

If it were me, I'd just keep drinking bourbon until I figured things out, stagger over to the drill press or whatever, and plunge ahead. It's just a hole. Try not to drill through the sides or bottom of the bowl. If you miss, just plug the hole up with plastic wood or something and try again. You may want to read my book, Why I am Not a Pipemaker, by Wilbur Whippit, a nom de plume.
Back to top Go down
View user profile
MichaelM

avatar

Age : 52
Location : Souderton, PA
Registration date : 2014-02-13

PostSubject: Re: A technical question   Sat Dec 30, 2017 9:11 am

You probably already know this, but you have to drill the mortise and the airway on different angles:



The problem is that when the bend becomes extreme you wind up drilling into the mortise wall. †Some makers will cap this off with a shank extension so it is never seen, others just leave it since you only see it when the stem is off.
And bourbon helps Wink
Mike.
Back to top Go down
View user profile https://www.youtube.com/channel/UCha16KUMQOZfkW_RgR7eA3Q
Crafty



Location : North Alabama
Registration date : 2013-09-06

PostSubject: Re: A technical question   Sat Dec 30, 2017 1:00 pm

Mike, thatís was pretty much the same conclusion I was at. Was hoping someone else had a trick to share! Very Happy BTW, Four Roses Single Barrel is excellent if you have never tried!
Back to top Go down
View user profile
huffelpuff

avatar

Age : 48
Location : Laramie, WY
Registration date : 2011-12-10

PostSubject: Re: A technical question   Sat Dec 30, 2017 5:16 pm

For really extreme bends you can actually drill in from the back just like itís a straight pipe, then come in from the mortise. You then make a plug for the bottom hole that can be removable or not as you see fit. The big issue is you canít be off even a little bit on the drilling. Iíve only seen this done once and it was a very old very homemade rustic pipe that was never made to be sold. The guy that made it was not a pipe maker just desperate for a smoke lol. Not sure I would really recommend trying this but it has been done if you choose to try I would absolutely want to see how it turns out. I would also recommend you try this out using wood other than precious briar.

Jim
Back to top Go down
View user profile
 
A technical question
Back to top 
Page 1 of 1
 Similar topics
-
» Theme/Background question
» When Reseting Passwords add a Security Question(s)
» Question about forum securities?
» Credits question?
» Question on private forum

Permissions in this forum:You cannot reply to topics in this forum
Brothers of Briar :: Pipes & Tobacco :: DIY-
Jump to: